Is the rail length the same as pull-out travel?

No. The rails overlap, so usable travel is shorter than the nominal rail length. Use the size table before ordering.

Top or bottom mount110 lb working loadLocks when extended

Pull-Out Worktop Slide Kit

No reviews yet

SKU CX-BW-SL

Hidden Worktop Extension

PULL-OUT WORKTOP EXTENSION KITCreate a hidden countertop, desk, prep surface, or window-bench worktop. Includes one pair of rails and a front locking latch; this is not a standard drawer-slide kit.
TOP OR BOTTOM MOUNTInstall with conventional cabinet side panels or use a concealed bottom-mount structure. The moving panel still needs suitable side-frame or edge support.
EXTENDED-POSITION LOCKING LATCHThe front latch secures the worktop when fully extended to reduce unwanted movement. It locks the extended position only and is not a closed-position travel lock.
COLD-ROLLED STEEL, 110 LB WORKING LOADBuilt for everyday countertop and desk extension use when installed in a rigid cabinet structure. Not for sitting, standing, steps, beds, or heavy long-cantilever platforms.
CHECK SIZE BEFORE ORDERINGAllow at least 3 mm clearance, verify the approximately 53.2 mm installed height, and remember that pull-out travel is shorter than rail length because the rails overlap.

Two mounting layoutsUse a conventional top-mount cabinet layout or conceal the rails under the moving worktop.

Extended-position latchA front latch helps keep the worktop from retracting while it is being used.

Compact hidden storageThe worktop slides back into the cabinet instead of occupying permanent floor or wall space.

Cold-rolled steel railsA 2.0 mm steel structure supports everyday desk and countertop extension use when the cabinet is rigid.

From the Brand

Choose it when the surface should disappear into the cabinet after use.

The decision is about structure and travel: confirm the cabinet bay can support the moving panel, choose top or concealed bottom mounting, and allow for rail overlap before selecting length.

Kitchen counter extensions
RV and camper worktops
Window-bench desks
Compact workstation surfaces

Application

Kitchen prep surface

Extra counter area that stores inside the cabinet.

Application

Concealed desk rail

Bottom-mounted hardware under a supported panel.

Application

Latched worktop

Controlled use in the fully extended position.

Application

Custom cabinet build

A measured installation for compact furniture.

Product information

Rail length and usable pull-out travel are different.

Compare the nominal rail length with the shorter travel created by the required overlap, then verify cabinet height and latch clearance.

Before ordering

Measure cabinet depth and choose a rail length that leaves room for the rear structure.
Allow about 53.2 mm installed height and at least 3 mm working clearance.
Support the moving panel from the required side frame or edge structure.
Position the front latch so it is reachable and aligned when fully extended.

Install & support

Questions that change the setup.

Does the latch lock the worktop closed?

No. The supplied latch locks the worktop in the fully extended position. Use a separate travel restraint if the installation must stay closed in a moving vehicle.

Can the rails be hidden under the worktop?

Yes, when the cabinet and moving panel include the side-frame or edge support shown in the installation diagram.

Fit & selection guides

Review 4 fit checks. Use only the guides you need.

Before you drill

Keep the final setup serviceable.

Moving panel supportDo not rely on the rails alone to replace the surrounding cabinet structure. The moving panel still needs the support shown for the selected mounting method.

Vehicle installationsThe latch holds the extended position only. Add a suitable closed-position restraint before treating an RV or camper installation as travel-ready.

Need help confirming fit?

Send the cabinet opening, available depth, panel width, mounting method, and intended load if you want help confirming fit.

Open Technical Support

Customer Reviews